tensile force

There is thus no tensile force in the plate girders.

The method has excellent strength because the steel is on the outside, where tensile forces are often greatest.

Wood is by far the cheaper of the materials, and when joined correctly, it can hold tensile forces.

Fishing line weight is described in pounds of tensile force before the line parts.

Drawing is a metalworking process which uses tensile forces to stretch metal.

The tensile forces and to run over sheaves with relatively small diameters.

The resistance it provides is more due to the tensile force of the springs rather than their weight, though they would contribute somewhat.

For applications that exert high tensile forces on the tether, the materials need to be strong and light.

(a) Consider the failure of pin under double shear due to tensile force.

Pressure vessels are held together against the gas pressure due to tensile forces within the walls of the container.

Tensile forces are taken on the studs, not the cylinder block or crankcase.

This shape eliminates tensile forces in the concrete.

Reinforcement with geocells provides tensile force to the soil to better resist instability.

Contrecoup injury may be produced by tensile forces.

In contrast, sheer or tensile forces can easily form cracks in ceramics and cause failure.

Compressive and tensile forces develop in the direction of the beam axis under bending loads.

Spring washer - used to apply a constant tensile force along the axis of a fastener.

Wet strength is routinely expressed as the ratio of wet to dry tensile force at break.

Tension members are structural elements that are subjected to axial tensile forces.

Thus, on cooling a strong tensile force acts on the glass-to-metal interface and it breaks.

"The protective cables vent the blast while at the same time act as a barrier against flying shards by means of tensile forces."

Ideally tension members carry tensile forces, or pulling forces, only and its end connections are assumed to be pinned.

The chevron test uses a special notch geometry for the specimen that is loaded with an increasing tensile force.

The entire tensile force across the engine was taken on these studs, with no tension being placed on the crankcase.

If this is subjected to a balanced pair of tensile forces F, its length changes by an increment dx so that.