Weitere Beispiele werden automatisch zu den Stichwörtern zugeordnet - wir garantieren ihre Korrektheit nicht.
He eased his baton in its retaining ring, let it fall back.
After the rear cover, a retaining ring is placed.
The retaining ring is made of steel and is a press fit.
The following are various surface finished used on retaining rings:
The shoulder on the outside and the retaining ring also keep the tire in place if the interference fit is lost.
This plug has a retaining ring, so you could not force it out even if you wanted to.
Replace the retaining ring or clip, then reattach the handle.
The same thing happens when a beveled retaining ring is installed into an application.
She threw back her head and moaned, wrists still locked in the retaining rings.
The retaining ring (Figure 1) keeps the wafer in the correct horizontal position.
It also does not require the extra rubber seals and a very high pressure crystal retaining ring.
"The weather wore away the retaining ring of mortar.
Spiral retaining rings have no ears or lugs to interfere with the assembly.
There is also another kind of stopper that connects to the pivot rod with a retaining ring.
Narrow transverse cuts could make buckles, bracelets, or retaining rings.
Self-locking retaining rings may be installed in applications where no groove exists.
These rings are manufactured by coiling flat wire into the shape of the finished retaining ring.
This caused the clapper to snap harder and harder against its retaining ring.
You can remove a retaining ring by unscrewing it with a pair of channel-type pliers.
Beveled retaining rings feature a 15 beveled or angled edge.
Hydraulically operated rolls swage the groove down on to the retaining ring.
"The retaining rings," prompted the judge.
A small plastic retaining ring is often fashioned against the stem, a toothpick, in order to prevent the umbrella from folding up spontaneously.
The principle is simple enough: remove the retaining ring, stretch the tubing back into place, and tighten the ring over it again."
Radially assembled retaining rings are installed externally into machined grooves on a shaft.
