That approach reduces the number of point-to-point connections between communicating applications.

We apparently generate a large subspace point-to-point connection and then move through it.

Today scientists do not look for point-to-point connections between existing and transplanted cells as they did in the past.

In this point-to-point connection the controller is the master and the boiler the slave.

For each point-to-point connection, the dynamic system behavior is defined by a connection state machine.

A point-to-point connection is made between "Agent" and a "Manager".

The Hub Interface was a point-to-point connection between different components on the motherboard.

These addresses are only valid on links (such as a local network segment or point-to-point connection) connected to a host.

Traditional voice calls are predominantly two party calls, requiring a point-to-point connection using only the voice medium.

The use of IPsec as a communication link requires a point-to-point connection establishment.

Boeing argued that travelers preferred point-to-point connections that could be served with smaller planes.

These specialised point-to-point connections provide dedicated bandwidth.

Originally, submarine cables were simple point-to-point connections.

The number of connections needed to have fully meshed point-to-point connections, with points, is given by .

(See Rent's rule for a discussion of wiring requirements for point-to-point connections).

The field telephone 50 is used by all communication troops of the Swiss Army for both point-to-point connections and landlines.

The company used radio equipment manufactured by Lucent and Alcatel to establish point-to-point connections.

The transport layer is not needed and is not present in devices that are intended for only point-to-point connections.

The communication model supports the topology of one or more Agents communicating over point-to-point connections to a single Manager.

In local area networks with a star topology, each network host is connected to a central hub with a point-to-point connection.

Thus, for ten applications to be fully integrated point-to-point, , or 45 point-to-point connections are needed.

In telecommunications, a point-to-point connection refers to a communications connection between two nodes or endpoints.

This allows computers to have dedicated bandwidth on point-to-point connections to the network and also to run in full duplex without collisions.

This is done by establishing a virtual point-to-point connection through the use of dedicated connections, encryption, or a combination of the two.

If integration is applied without following a structured EAI approach, point-to-point connections grow across an organization.