Weitere Beispiele werden automatisch zu den Stichwörtern zugeordnet - wir garantieren ihre Korrektheit nicht.
Based on the model, the current operating point of a production system can be analysed.
The following equations can be used to estimate the new operating point.
A change in speed out of this stable operating point is only possible with a new control intervention.
These models have been constructed to represent the system in the neighborhood of the current operating point.
From an operating point of view, their results compared very favourably with the sector.
To find the output operating point, the input bias current is needed.
By similar process as above, the change is negated and operating point kept stable.
We do not believe that the lowest possible variance is the most desirable operating point.
The software has to solve the mass and energy balance to find a stable operating point.
Due to this change the operating point will shift.
Once the steady state solution is found, the operating points of each element in the circuit are known.
But when the operating point is instable then the characteristics of drive and machine are nearly parallel.
From here, a circuit designer can choose the operating point of the particular triode.
The point where the lines cross is the quiescent operating point.
For this reason this operating point does not have a stabilizing effect on the speed.
This of course would mean the two turbomachines being compared are geometrically similar and running at the same operating point.
The operating point is hard-wired and cannot be adjusted.
Good stability of operating point similar to voltage divider bias.
The value of doesn't change for a wide range of operating points till stalling.
The operating point is a specific point within the operation characteristic of a technical device.
It generally produces a very pleasant "tube-warmth" effect when the operating point is properly set.
Running at an instable operating point is therefore undesirable.
Because an increase in collector current with temperature is opposed, the operating point is kept stable.
The circuit has the tendency to stabilize operating point against changes in temperature and β-value.
Hence for at a given operating point with current i and flux linkage :
Wörterbuch der Technik und Mechanik