needle file

Failing that, use the edge of the half round needle file.

I feel compelled to add another chapter to the Needles files.

A round needle file is used to make a small depression across one end to provide a seat for the ring section.

I often use a small needle file to ascertain the height needed for the post.

I then make about nine teeth around the edge, with a three-square needle file.

Use a needle file to deburr each section and finish them to your satisfaction.

I tripped it open with my needle file.

Half round needle file individual 140mm.

The six-piece needle file set includes hand, flat, square, half-round and round files.

Needle files for small precision work.

They are called needle files.

Some files, like needle files, have integral handles.

The image to the left shows a selection of needle files in an assortment of cross sectional shapes.

It seemed impervious to needle files, invulnerable to penknives, invincible against wires.

Set of metal needle files.

The tools of Ian's trade are mainly those of the watchmaker including lathes, needle files and eyeglasses.

All of the wheels have very thin resin between the spokes which will clean up with carefull use of a very small needle file.

After removing the part, hold it in a pair of good quality flat nosed tweezers and file off the join mark with a fine needle file.

Meanwhile the BMW was still off the pace so it was Scrotee's turn to have a go at the jets with the needle file.

The shelf of half-finished settings and racks of pliers, needle files, triblets and mallets surrounded him accusingly.

A small mill or needle file may be handy for removing the small spur that sometimes remains at the end of the blade path, but otherwise its use is rather limited.

Needle files are small files that are used in applications where the surface finish takes priority over metal removal rates but they are most suited for smaller work pieces.

Drill the holes undersize, and finish off with a needle file, as the gelcoat will chip away and leave a marred finish on an otherwise perfect fuselage, if you attempt to drill out to full size.