Weitere Beispiele werden automatisch zu den Stichwörtern zugeordnet - wir garantieren ihre Korrektheit nicht.
You need to take it into the shop and have a lock washer put on the nut.
We are frantically adding locking washers as different parts work themselves loose!
Now they are retained by a locking washer and ours didn't budge.
Bolts will be provided with a nut and single coil spring lock washer.
In the locknut form, this is a star-type lock washer.
The fastener serves the functions of both a lock washer and a nut.
Against the head of each setscrew is a lock washer, (Part No.
It has a lock washer inside that secures it to the pipe.
Put on the bracket then add washers, lock washers and nuts.
A locking washer locks this nut in place, which was still in place.
There was no wire locking or lock washer and none were specified in the aircraft's Maintenance Manual.
Install with small washers and lock washers.
Always use a new lock washer or star washer, usually with a plain washer to spread the load and stop damage to parts.
Place the mid/center pipe up to the converter and hand tighten the supplied lock washers and 14 mm nuts.
For Cohu cameras we attach the piece approximately seven inches past the top of the factory sun shield using small bolts, nuts and lock washers.
Common washer types are star-type lock washers, conical, and flat washers. '
The use of a lock washer or crush washer was rejected as their use can increase visible flash from the shooter's perspective.
Locknuts, jam nuts, lock washers, and thread-locking fluid are ways to prevent vibration from loosening a bolted joint.
Check that racks are installed with medium strength Loctite, or use lock washers or nylon locknuts on any mounting bolts.
Image 2: Tabbed Lock Washer / Plates This material is presented for information purposes only.
Lock washers, locknuts, jam nuts, and safety wire may be used in conjunction with thread-locking fluid to prevent loosening of bolted joints.
All chassis fasteners should have some type of locking device (lock washers, cotter pins, self locking nuts, or safety wire) installed.
Bolt the rear pipe to the front pipe using the 3 supplied bolts/nuts/lock washers and new gasket and tighten with your 14mm socket wrench.
We are frantically adding locking washers as different parts work themselves loose!
Now they are retained by a locking washer and ours didn't budge.
A locking washer locks this nut in place, which was still in place.
Designed specially for Paul's Fishing Kites, these reels include teflon bushes, heavy duty glavanised steel brackets and handles, locking washers and end caps.
This forced water behind the nuts and locking washers on the engine and found its way into the Isolastics, causing bolts, studs and shims to corrode and seize.
Locking washers, which prevent fastening loosening by preventing unscrewing rotation of the fastening device; locking washers are usually also spring washers.
One of the nuts on the main pivot bolt attaching the fish to the winch cable was missing despite a steel locking washer, and the pivot bolt had shifted more than 30mm to one side.
Boat Propeller (107102) This boat propeller consists of: 2-3 blade propeller housings, shock absorbing drive hub, splined locking washer, thrust washer, spoked tab washer and a nylon lock nut that is designed to be attached to the boat motor.
