layer of mortar
mortar layer

Spread a similar layer of mortar on the top and sides of the brick.

Jordan had scraped away the top layer of mortar around the stones he wanted cleared.

Another layer of mortar is spread, then insulation poured in between, more logs follow and so on.

Such a process is aesthetically undesirable and can cause performance problems as a thin layer of mortar will quickly erode.

This involved topping all but one of the stones with layers of mortar and limestone slabs.

It is built of irregular stone blocks and brick embedded in thick layers of mortar.

The mortar gaps are filled to make a relatively flat top surface, then another thin layer of mortar is added and the process repeats.

A. If the concrete is fairly rough you can get by with spreading a latex masonry adhesive over it, then a layer of mortar.

To avoid this I propose to place a layer of mortar on the lining and lay bricks on top which will be covered by slabs.

The blazon and the motto would be hidden under a layer of mortar to avoid the furies of the Revolution.

On site, this section is then set into a fresh layer of mortar which has been smeared across a hardened mortar layer.

Caulking also can be used to cover the seam where the chimney cap - the layer of mortar on top of the chimney - meets the flue.

All of them (a dozen large ones and hundreds of small ones) were built with roughly cut stone (natively called - lomljenac) bounded with thick layer of mortar from outside.

He picked up a brick, holding it upright while he applied a thick layer of mortar to one end with a trowel, beveling the soft cement as if it were a gritty gray cheese.

Based on the catalan vault he created the Guastavino tile, a "Tile Arch System" patented in the United States in 1885 used for constructing robust, self-supporting arches and architectural vaults using interlocking terracotta tiles and layers of mortar.

It is a technique for constructing robust, self-supporting arches and architectural vaults using interlocking terracotta tiles and layers of mortar to form a thin skin, with the tiles following the curve of the roof as opposed to horizontally (corbelling), or perpendicular to the curve (as in Roman vaulting).

The tabernae had a floor made of stone chips and a mortar layer.

During the excavation of 1934/1935 up to four mortar layers covered with frescoes on blue background were uncovered.

On site, this section is then set into a fresh layer of mortar which has been smeared across a hardened mortar layer.

Due to that, the thickness of the mortar layers is about three times greater than that of the brick layers.

Noxer blocks are concrete pavers that feature a 5-7 mm thick coating of titanium dioxide (TiO) atop a cement mortar layer.

When using the direct method, tesserae are placed by hand into a layer of fresh mortar spread in small patches across the hardened, penultimate, mortar layer,(hence the possibility of guidelines, see above).