feed end

The columns were fed continuously with pulp from the feed end of the plant flotation circuit.

It can contain multiple sections as the material travels from the feed end to the discharge end.

It consists of a perforated cylindrical drum which is normally elevated at an angle at the feed end.

The disks contain slots to allow the ore slurry to pass from the feed end to the discharge end (see Figure 3).

Concentrated sulphuric acid is added to the ore at a typical rate of 10 kg/t, via a spray bar at the feed end.

At the end of the operation the feed end spray is again turned on to prevent the tail of the operation becoming overdried.

A burner at the feed end of the sinter machine ignites the carbon in the mix on the pallets, and air is drawn down through the material.

Plastic dust caps were later issued to cover the feed end of the magazine and keep out dust as well as protect the sensitive feed lips.

Then, after little more than two laps aloft, both plasma tubes delami-nated at the feed end, burning dead spots in the crystal and forcing him from the race.

The dryer slopes slightly so that the discharge end is lower than the material feed end in order to convey the material through the dryer under gravity.

The relatively short distance between the last disk results in a centrifugal action that forces coarse particles towards the mill shell, from where they flow back towards the feed end.

When designing this type of installation it is important to fully consider the loading at the feed end of the track, especially when subsidiary cross tracks are connected to it.

Ledges at the feed end of the cylinder have been engineered out to prevent tobacco build up. Additional washdown nozzles of the tank cleaning type have been added.

In order to determine gold grades and recovery, each stockpile will initially be weighed and sampled at the feed end, with additional samples taken from the tailings stream and gold concentrate.

Also, the direction of flow of feed through the mill was reversed, because most of the disk wear occurred at the feed end, which was initially at the drive end of the mill.

For us at Better Beef, financing with FCC will help us grow our industry, make our farmers more prosperous and make it easier for young producers to get into the feeding end of cattle production."

By changing the feed end to that opposite the drive end, the disks that required most frequent replacement were the first that were removed from the shaft rather than the last (see Figure 6 and Figure 7).

Some designs have a short conical section at the feed end for prethickening within the unit, but generally it is preferable to thicken before entering the centrifuge with gravity settlers, hydrocyclones or inclined screens, producing a higher concentration of solids.

This gas stream can either be moving toward the discharge end from the feed end (known as co-current flow), or toward the feed end from the discharge end (known as counter-current flow).

Percent F Funds When Chance of Rate at Will Inter- Fed Fed End of Easing meeting Action Action Easing Cycle COMPANY Cut Jan 30 March 18 Cycle End?