core plug

Fortunately there is a core plug which I knocked out.

This is often overlooked, even when other core plugs have been replaced.

Go find Below are two views of the core plug extractor that I had to make.

Core plugs can often be a source of leaks due to corrosion caused by cooling system water.

The company analyzes rock core plug samples taken from exploration wells in the petroleum sector.

Each direction in core plug measurement yields three velocities (one P and two S).

A fluid of known viscosity is injected into the core plug while mounted in a steel chamber.

Core plugs are usually thin metal cups press fitted into the casting holes, but may be made of rubber or other materials.

Difficulty or ease of core plug replacement depends upon physical accessibility in a crowded engine compartment.

Hey presto, the core plugs were like sieves.

Since most shales are very friable and fissured, it is often difficult to cut shale core plug.

Other core plugs have a dish design, so that when pressed into the casting hole the tapered sides form the seal.

On the underside of the expansion chamber there is a core plug - a thin, metal disk, blanking off a hole.

The machine automatically applied adhesive and inserted core plugs, one at a time, into ten machined holes.

This core plug has dripped ever since I bought Rosy, and I've been meaning to do something about it for some time.

The tiny church itself sits atop of the core plug of an extinct volcano and it retains that shape.

The core plug often binds inside the hole saw, and often must be pried out after each hole is cut.

A complete suite of evaluation logs were run from 14,250 feet to total depth and 17 sidewall core plugs were obtained.

Careful preparation of the core plugs was made to ensure reliable measurement of formation factor and porosity.

However, glauconitic microporosity is measured as part of the effective porosity in core plugs, even if they are humidity dried.

Core plugs are used to fill the sand casting core holes found on water-cooled internal combustion engines.

In some high-performance engines the core plugs are large diameter cast metal threaded pipe plugs.

Failure to do this periodic maintenance accelerates corrosion of engine parts, and the thin metal core plugs are often the first components to start leaking.

Permeability is measured in the laboratory by encasing a core plug of known length and diameter in an air-tight sleeve (the Hassler Sleeve).

However, the CBW retained by the humidity-dried core plugs is not necessarily representative of CBW in the formation at reservoir conditions.