clutch housing

Both cable and rod shift mechanisms are available, as well as application-specific clutch housings.

Evolutionary engineering changes included positive crankcase ventilation, a smaller flywheel, and an aluminum clutch housing.

Magnesium is used for the clutch housing, fuel injection manifold, and manifold adapter plate.

Mechanical changes included a stiffer frame, and a Cuno self-cleaning oil filter mounted at the right hand side of the clutch housing.

The sump, camshaft cover, timing cover and clutch housing were in lightweight magnesium alloy instead of the standard aluminium alloy.

The TR-6060 contains removable wear pads on the shift forks, and uses aluminum alloys for the main case, extension housing, and clutch housing.

This was after a supposedly top-of-the-range P6 was revealed to have consumed three engines, two gearboxes, two clutch housings and entirely new cables - after just 6,000 miles.

The main gearbox was located behind the cabin and connected to the engine clutch housing via a short cardan shaft (this design enables a so-called flat floor cabin.)

It reported that a Rover 3500 purchased in 1974 had covered 6,000 miles (9,600 kilometers) during its first six months, during which period it had consumed three engines, two gear boxes, two clutch housings and needed a complete new set of electrical cables.

However, whilst the dry clutch variants may be limited in torque compared to their wet clutch counterparts, the dry clutch variants offer an increase in fuel efficiency, due to the lack of pumping losses of the transmission fluid in the clutch housing.

Product ranges include Cylinder Blocks, Cylinder Heads, Flywheels, Flywheel Housings, Transmission Casings, Clutch Plates, Brake Drums, Intake Manifolds and Clutch Housings for HCV,LCV and car segments.

Engineers calculated that torsional stresses would be too high if they took power from the end of the long crankshaft, so they put a central gear train in the middle (which also ran the dual camshafts, dual magnetos, and other accessories) and ran a drive shaft to the clutch housing at the rear.