catalytic cracker
cat cracker

But chemical engineers said they could find no record of an explosion by a catalytic cracker.

The estimated cost of expansion was $320 million, with a hydrocracker now considered rather than the planned catalytic cracker.

In 1973, the government approved a NZ$160 million expansion of the refinery, involving the addition of a fluid catalytic cracker.

Fluid catalytic cracker (FCC) unit upgrades heavier fractions into lighter, more valuable products.

Catalyst coke is coke that has deposited on the catalysts used in oil refining, such as those in a fluid catalytic cracker.

The first stage of this expansion, which came on-stream in 1951, consisted of primary distillation units, a catalytic cracker and numerous treating units.

During World War II, the plant constructed its first catalytic cracker, or "cat cracker", which went into operation on January 18, 1943.

The major work was the installation of the Residue Fluid Catalytic Cracker (RFCC).

In 2002 the Tema Oil Refinery in Tema was fitted with a residual fuel catalytic cracker.

May 5, 1988: Norco, Louisiana, Shell Oil refinery explosion after hydrocarbon gas escaped from a corroded pipe in a catalytic cracker and was ignited.

The new plant will provide sulphur-free diesel and mean different types of crude oil can be processed, that can be made in a conventional catalytic cracker or hydrocracker.

In its previous life, the titanium hull of SubLorraine was a high-pressure heat exchanger pulled from the effluent side of a catalytic cracker unit at Marathon Refinery.

One of the most modern facilities of its kind in the world, it employed everything from smelters, catalytic crackers and v-written enzyme digestion right up to ionic fission for toxics.

The refinery consists of crude units, visbreaking units, fluid catalytic cracker, light products plants, polymerization plants, amine plants, sulfur plants, and impurities treatment plants.

In the 1980s, a fluid catalytic cracker, an alkylation unit, a visbreaker, and an MTBE (Methyl tert-butyl ether) unit (for high octane petrol) were added.

Gulf also participated in a partnership with other majors, including Texaco, to build the Pembroke Catalytic Cracker refinery at Milford Haven and the associated Mainline Pipelines fuel distribution network.

The steam turbine shown in Figure 5 is used to drive the regenerator's combustion air compressor during start-ups of the fluid catalytic cracker until there is sufficient combustion flue gas to take over that task.

The combustion flue gas from the catalyst regenerator of a fluid catalytic cracker is at a temperature of about 715 C and at a pressure of about 2.4 barg (240 kPa gauge).

The world's biggest catalytic cracker is cracking, crude and gas and diesel are surging through 675 miles of blue and gray pipe, the intermittent "psssht" of venting steam rises above the hum of compressor motors.

As the refinery grew, additional processing units were built to produce lubricants and aromatic chemicals, and with the addition of the fluid catalytic cracker in 1952 and the 736 coker in 1968 the refinery emerged as one of the earliest full-conversion refineries on the Texas Gulf Coast.

ESPs continue to be excellent devices for control of many industrial particulate emissions, including smoke from electricity-generating utilities (coal and oil fired), salt cake collection from black liquor boilers in pulp mills, and catalyst collection from fluidized bed catalytic cracker units in oil refineries to name a few.

If the feed does contain olefins (for example, the feed is a naphtha derived from a refinery fluid catalytic cracker (FCC) unit), then the overhead gas from the HDS stripper may also contain some ethene, propene, butenes and pentenes, or heavier components.

During World War II, the plant constructed its first catalytic cracker, or "cat cracker", which went into operation on January 18, 1943.

Designated HVU for CCF (cat cracker feed).

Fluid catalytic cracking is a commonly used process, and a modern oil refinery will typically include a cat cracker, particularly at refineries in the US, due to the high demand for gasoline.

Polybutene is typically made from cat cracker mixed C4s (after the stream is Merox treated to remove sulfur and amines, and contain 1-butene, 2-butene, and isobutylene.

Because the demand for gasoline, compared to other petroleum products, is much greater than the supply that naturally occurs from distillation, some of the heavier components are sent on to the catalytic cracking unit, commonly known as the cat cracker.